CHEP Electronic Bed Leveling Tool Kit
As described in this video:
https://youtu.be/715Xop79SusThis tool can give you visual feedback on when to stop adjusting the bed level knob when leveling the bed on any 3D printer.
This kit includes:
- Circuit Board
- Momentary Switch (requires bending leads to create surface mounting)
- Red 5mm LED
- 100 ohm resistor
- 2032 Battery Holder (must cut off back side locating tabs)
Note: 2032 3v Coin Cell Battery is NOT INCLUDED.
Due to popularity, this item is delayed shipping estimated at 3 days.
Note: USA Postal won't allow us to AirMail to Australia or New Zealand due to Covid Restrictions
